The convenience of the Great Stuff™ Window & Door Foam Sealant Kit is that it has everything you need to reduce unwanted airflow and improve energy efficiency in one easy to manage kit. GREAT STUFF PRO™ Window & Door Polyurethane Foam Sealant is a specially formulated, minimal-expanding foam with a low pressure-build that remains soft & flexible after curing.
Using our GREAT STUFF™ Contractor Kit is easy. Pop the top off the can; screw it onto the gun; open the gun's valve; pull back the trigger and you are good to go. Still have foam left? Leave the can attached to the gun and close the valve until the next use. Use the cleaner on the outside of the gun and clean the inside when you are going to store it for a longer time. After you use the cleaner, remember to remove the can and empty the cleaner from the gun.
1 70 ± 5°F and 50 ± 5 % RH, 1-inch bead diameter, 6-inch length. The cure rate is dependent on temperature, humidity, and size of the foam bead.
Q.Are the Great Stuff™ Insulating Foam Sealant and Great Stuff Pro™ Polyurethane Foam Sealant cans recyclable and are there restrictions on their disposal?
A. Since local regulations vary, it is best to contact your local waste disposal facility to inquire about disposal of pressurized aerosol cans. DuPont manufacturing facilities are typically not licensed to receive hazardous waste and therefore cannot take back used canisters. If you have additional questions, call our DuPont Contact Center (DCC) at 1-833-338-7668. Please see this document for more information surrounding the disposal and recycling information of Great Stuff™ and Great Stuff Pro™ Polyurethane Foam products.
Q.Can I clean the Great Stuff™ Black gun?
A. Yes! Unscrew used Great Stuff Pro™ from dispensing gun. Clean the gun basket and tip by generously spraying and removing uncured foam with Great Stuff™ Foam Cleaner. Invert the can and install the cleaner onto the dispensing gun. Press the trigger to flush the foam into waste receptable until only the cleaner is visible. Allow gun to sit for several minutes and repeat with a second flush. Remove the can from the dispensing gun and spray into waste receptacle without the can until the gun is completely empty.
Q.How do I get Great Stuff™ foam off of my skin?
A. If the foam has not cured or hardened, use fingernail polish remover (with acetone); a polyglycol-based skin cleanser or corn oil may be effective. Then wash with soap and plenty of water. If the foam has hardened, there is no solvent that will remove it. It will not harm your skin and will wear off over time. To remove cured foam from skin, use a pumice stone (available at most drug stores) and warm, soapy water. Then apply petroleum jelly.
Q.How many windows can one can of GREAT STUFF™ Window & Door fill?
A. Fills an average of four to six residential windows (36" x 60", a 3/8" gap, 1" deep) with a single 12-oz. can
Q.Where to use Great Stuff Pro™ Window & Door
A. Windows and their rough openings Doors and their rough openings
© 2024 DuPont. All rights reserved. DuPont™, the DuPont Oval Logo, and all trademarks and service marks denoted with ™, ℠ or ® are owned by affiliates of DuPont de Nemours, Inc. unless otherwise noted.